TP-Link, Linksys, Zyxel, Netgear, ASUS use 192.168.1.1 IP to identify themselves on the network. 192.168.1.1 IP address is set by default for these routers on the factory. You can change this address to any IP you want but typically it is not necessary unless you have another device on your network which needs this IP address. To change settings of your router you need to access router 192.168.l.l IP address.
Typically you can access this IP address from your browser. Below are the steps to quickly do it:
- Open your browser and enter 192.168.1.1 in the address bar or just navigate to this link: 192.168.1.1
- If you don’t see a router configuration interface you need to make sure that your router is using 192.168.1.1 IP address to identify itself. To do it you need to find out router IP address.
- Once you identified your router IP address navigate to it.
- Router will prompt you for username and password. Enter this information into corresponding fields.
- Press “Submit” or “Login” button to proceed. If login information entered in the previous step is correct you should see router administration interface.
Default router credentials
If you don’t know password and username for your router you should check them in the table below to see if default password will match. Often router default login information is used when setting up the network and default username and password might work.
If you don’t see administration interface on 192.168.1.1 IP address you can quickly check if 192.168.0.1, 192.168.1.254 or 192.168.2.1 work. These IP addresses are also frequently used as default to identify routers.